Dismiss Notice
We are rebuilding the search index and other forum caches this morning. Search results may not appear correct until indexing has completed, and the forum may respond a little slower than normal until this has finished.

[Help needed]: phono stage settings for Dynavector 20X2L

Discussion in 'Audio Hardware' started by soulboogaloo, Apr 19, 2017.

Thread Status:
Not open for further replies.
  1. soulboogaloo

    soulboogaloo Well-Known Member Thread Starter

    Location:
    Versailles, France
    Hey guys,

    just bought a Dynavector MC 20X2L cartridge, and I'm not too sure how to set my phono stage (a Lehmann Black Cube)
    The cartridge's specs sheet says : "Recommended load : >1000 ohms / 30 ohms"
    Here are the possible settings for my phono stage (I currently set them to 100 ohms, which was the value I used with my other cartridge):
    [​IMG]

    Thank you guys in advance for the help!!!
     
  2. deadcoldfish

    deadcoldfish Senior Member

    Location:
    Santa Rosa, CA
    The Spec sheet is for both the High Output and Low Output versions:
    The cartridge's specs sheet says : "Recommended load : >1000 ohms / 30 ohms"

    The >1000 ohms is for the High Output (20X2H)
    The >30 ohms is for the Low Output (20x2L).

    Try it at 100 or 80 ohms.
     
    avanti1960 likes this.
  3. soulboogaloo

    soulboogaloo Well-Known Member Thread Starter

    Location:
    Versailles, France
    Thanks a lot @deadcoldfish !!! I must confess the spec sheet was not really obvious for me...
    So I'm going to keep at 100 ohms like it was...
     
  4. Guildx500

    Guildx500 Forum Resident

    Location:
    California
    I run mine at 100 though I liked it all the way up to 500.
     
Thread Status:
Not open for further replies.

Share This Page